Ricoh PRO C7210

1.SC Codes
151
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
1. Check the harness connection.
2. Replace the encoder harness.
3. Replace the Exit Motor.
4. Remove torn paper from the paper path, remove foreign objects from the
drive area, and check for motor/motor bracket deformation.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC702-
04
D
Protection device break error 4 (1-pass ADF)
The non-interlock power supply system protection device broke the circuit with the
24V power supply on.
 Motor defect in non-interlock power supply system.
 Harness broken
Check if the SC occurs (feed paper, open/close the doors, Input or Output check).
If the SC occurs again, do the following steps.Check if the SC reoccurs by cycling
the power after each step.
 Replace the shorted parts.
 Replace the ADF Control Board.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC702-
05
D
Protection device break error 5 (1-pass ADF)
The non-interlock power supply system protection device broke the circuit with the
24V power supply on.
 Motor defect in non-interlock power supply system.
 Harness broken
Check if the SC occurs (feed paper, open/close the doors, Input or Output check).
If the SC occurs again, do the following steps.Check if the SC reoccurs by cycling
the power after each step.
 Replace the shorted parts.
 Replace the ADF Control Board.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC703-
01
D
Double feed detection error (1-pass ADF)
A signal condition that triggers an error was detected during double feed detection.
 Connecter disconnected
 Harness broken
 Double feed detection signal output error
 ADF Control Board defective