Ricoh PRO C7210 - Page 168

1.SC Codes
164
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 When moving from the home position, home position was still detected after
specified number of pulses. (The first time: jam display, the second time: SC)
 Motor defective
 Connecter disconnected
 Overload
 Home position sensor defective
 Replace the Booklet Stapler Side Fence Motor, reconnect the connector.
 Replace the Booklet Stapler Side Fence HP Sensors (front, rear), reconnect
the connectors.
 Replace the harnesses.
 Replace the Main Board.
 Resolve the mechanical failure for the booklet stack mechanism.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC720-
51
B
Booklet Bottom Fence Motor Error
Same as SC720-50
Same as SC720-50
 Replace the Booklet Bottom Fence Motor, reconnect the connector.
 Replace the Booklet Stapler Bottom Fence HP Sensor, reconnect the
connector.
 Replace the harnesses.
 Replace the Main Board.
 Resolve the mechanical failure for the booklet stack mechanism.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC720-52
B
Fold Plate Motor Error
Same as SC720-50
Same as SC720-50
 Replace the Fold Plate Motor Error, reconnect the connector.
 Replace the Fold Plate HP Sensor, reconnect the connector.
 Replace the harnesses.
 Replace the Main Board.
 Resolve the mechanical failure for the booklet stack mechanism.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC720-
B
Booklet Stapler Bottom Fence Motor Error