Ricoh PRO C7210

1.SC Codes
178
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Replace the Main Board.
 Replace the Crease Motor.
 Replace the harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC725-71
D
Horizontal Transport Motor Error
 Motor driver detected an error. (SC from the first time)
 Overcurrent to the motor.
 Motor drive overheat
 Replace the Main Board.
 Replace the Horizontal Transport Motor
 Replace the harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC725-72
D
Horizontal Exit Motor Error
 Motor driver detected an error. (SC from the first time)
 Overcurrent to the motor.
 Motor drive overheat
 Replace the Main Board.
 Replace the Horizontal Exit Motor.
 Replace the harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC725-73
D
Top Tray Transport Motor Error
 Motor driver detected an error. (SC from the first time)
 Overcurrent to the motor.
 Motor drive overheat
 Replace the Main Board.
 Replace the Top Tray Transport Motor
 Replace the harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC725-
74
D
Entrance JG Motor Error
 When moving to the home position, home position was not detected within
specified number of pulses. (The first time: jam display, the second time: SC)
 When moving from the home position, home position was still detected after
specified number of pulses. (The first time: jam display, the second time: SC)