Ricoh PRO C7210

1.SC Codes
188
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
rotation operation starts. (Regardless of whether or not recovery is successful,
the first time: SC)
 Trimming Blade Motor defective
 Connecter disconnected
 Overload
 Trimming Blade HP Sensor defective
 Main Board defective
 Reconnect the connector.
 Replace the connector.
 Replace the Trimming Blade HP Sensor.
 Replace the Trimming Blade Motor.
 Replace the Main Board.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC735-
11
B
Press Roller Motor Error
 When moving to the home position, home position was not detected within
specified time. (The first time: jam display, the second time: SC)
 When moving from the home position, home position was still detected after
specified time. (The first time: jam display, the second time: SC)
 Press Roller Motor defective
 Connecter disconnected
 Press Roller HP Sensor defective
 Main Board defective
 Reconnect the connector.
 Replace the connector.
 Replace the Press Roller HP Sensor.
 Replace the Press Roller Motor.
 Replace the Main Board.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC735-
12
B
Cut Position Motor Error
 When moving to the home position, home position was not detected within
specified time. (The first time: jam display, the second time: SC)
 When moving from the home position, home position was still detected after
specified time. (The first time: jam display, the second time: SC)
 Cut Position Motor defective
 Connecter disconnected