Ricoh PRO C7210

1.SC Codes
349
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Clear the signature jam
After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC754-
77
B
Perfect Binder: Drive switch motor error (down to up)
The rack where the drive gear is mounted did not retract from the drive switch
sensor after the drive switch motor operated for 3 s.
 Drive switch motor defective
 Drive switch sensor defective
 Connector loose, broken, defective
 Inserter control board defective
 Reconnect the connector.
 Replace the drive switch motor.
 Replace the drive switch sensor
 Replace the inserter control board.
 Replace the motor harness.
 Replace the sensor harness.
After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC754-
78
B
Perfect Binder: Drive switch motor error (up to down)
The rack where the drive gear is mounted was late arriving at the drive switch
sensor after the drive switch motor operated for 3 s.
 Drive switch motor defective
 Drive switch sensor defective
 Connector loose, broken, defective
 Inserter control board defective
 Reconnect the connector.
 Replace the drive switch motor.
 Replace the drive switch sensor
 Replace the inserter control board.
 Replace the motor harness.
 Replace the sensor harness.
After the repairs, cancel the low performance mode, and then turn the power
off/on.