Ricoh PRO C7210 - Page 361

1.SC Codes
357
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Reconnect the connector
 Replace the board
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC756-
41
B
Ring Binder: Clamp thickness error
 During jogging a 100-sheet stack was detected and the 50-sheet detect
sensor (S606) went OFF. (1st detection signals a jam, 2nd detection issues
this SC code.)
 When the clamp moved to the open release position at initialization, the 50-
sheet detect sensor went OFF.
 50-sheet detect sensor (S606) defective
 Connector loose, broken, defective
 Replace the connector
 Reconnect the connector
 Replace the board
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC756-
42
B
Ring Binder: Alignment pin error
 When moving to the home position, the sensor could not detect the
component at the home position within the prescribed time (400 ms). The first
occurrence triggers a jam, the second an SC code.
 The sensor failed to detect that the component had moved out of the home
position within the prescribed time (400 ms). The first occurrence triggers a
jam, the second an SC code.
 Alignment pin motor (M602) defective
 Motor overloaded
 Connector loose, broken, defective
 Alignment pin HP sensor (S604) defective
 Replace the motor
 Replace the sensor
 Replace the connector
 Reconnect the connector
 Replace the board
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC756-
43
B
Ring Binder: Pre-bind jogger shutter error
 When moving to the home position, the sensor could not detect the