7.Detailed Procedures of SC Occur
538
8. Remove the tension roller assembly [C] and tension roller.
9. Carefully move the ITB [A] to the non-operator side until the sensor [B] is uncovered.
It is recommended to wear gloves when moving the ITB.
Do not move the belt any more after the sensor is uncovered. Doing so could damage the
belt.
10. Clean the transfer belt speed feedback sensor [A].
Use a vacuum cleaner or an air blower to remove dust.
Wipe the sensor with a wet cotton swab. If a cotton swab is not at hand, wipe the sensor with a
damp cloth. Use water if necessary, but do not use any solvent (ethanol, etc).
To Next Page
Loading...
