12.Advanced Instructions
667
6. At [Setup] > [Terminal], open the Terminal Setup screen and specify the following settings.
Terminal Size : under (80x25)
New Line: Transmit CR+LF
Local echo: Check box on
7. At [Setup] > [Serial Port], open the Serial port setup screen and specify the following settings.
(x : check COM number with Device Manager of PC)
Baud rate : 57600
Date: 8 bit
Parity: none
Flow control : none
Transmit delay: 10 msec/char
8. At [File] > [Log], enter the file name and click “Open.”
9. Turn on the machine power switch. Enter “ver” in the “Teraterm” window and check for any
connection problems (Is a value returned? Is there a mistake for either master or slave?).
To Next Page
Loading...
