To Next Page

To Previous Page

cobas p 512

VIII Operator's Manual - Version 1.6 - 10/2015

4.4. Weekly device care .................................................................................... 4-1

4.4.1 Cleaning the decapper module ............................................................................... 4-1

4.5. Monthly device maintenance................................................................... 4-1

4.5.1 Cleaning system components .................................................................................. 4-1

4.5.2 Cleaning the barcode reader .................................................................................... 4-1

4.5.3 Cleaning the sensors on the RT-Transport ......................................................... 4-1

4.5.4 Cleaning the infrared liquid level detection (IR-LLD) ..................................... 4-1

4.5.5 Cleaning the laser liquid level detection (Laser-LLD) .................................... 4-1

4.6. Device care, as and when required ........................................................ 4-1

4.6.1 Cleaning the housing and component surfaces ............................................... 4-1

4.6.2 Cleaning the display ..................................................................................................... 4-1

4.6.3 Cleaning the sorting module grippers .................................................................. 4-1

4.6.4 Cleaning the sensors on the feed-in and output modules ........................... 4-1

4.6.5 Emptying the condensation container .................................................................. 4-1

4.6.6 Cleaning the tube type identification module (BlueLynx camera) ............. 4-1

4.6.7 Cleaning the quality module (QS I, QS I-LLD) ................................................... 4-1

4.6.8 Cleaning the recapper module ................................................................................ 4-1

4.7. Replacing parts ........................................................................................... 4-1

4.7.1 Replacing the mains fuse ........................................................................................... 4-1

4.7.2 Replacing the lighting of tube type identification module ............................ 4-1

5. Troubleshooting ..................................................................................... 5-1

5.1. What do I do if...? ........................................................................................ 5-1

5.1.1 ... the system is not working? ................................................................................... 5-1

5.1.2 ... the control unit (computer) is not working? .................................................. 5-1

5.1.3 ... the touch screen monitor is not working? ...................................................... 5-1

5.1.4 ... the communication in the network is not working? .................................... 5-1

5.1.5 ... the control unit (QNX PC) fails during operation? ....................................... 5-1

5.1.6 ... a power failure has occurred? ............................................................................. 5-1

5.1.7 ... no button is active on the touch screen monitor? ....................................... 5-1

5.1.8 ... daily data backup is causing problems?.......................................................... 5-1

5.1.9 ... the sorter unit does not put down the tubes properly? ............................. 5-1

5.1.10 ... problems occur when reading a barcode? ..................................................... 5-1

5.1.11 ... the recapping module is not working? ............................................................. 5-1

5.1.12 ... a tube is set down into an already-occupied position on the rack? ..... 5-1

5.1.13 ... the recapping module isn’t working? ............................................................... 5-1

5.1.14 ... the decapper does not release the cap or is jammed? .............................. 5-1

5.1.15 ... the QS I camera fails to classify the sample? ................................................ 5-1

5.2. Important questions for customer service ............................................ 5-1

5.2.1 General information ..................................................................................................... 5-1

5.2.2 Air pressure too low ..................................................................................................... 5-1

5.2.3 Problems with the motor control ............................................................................. 5-1

5.2.4 Problems with the tube transport at the in/ output sections ....................... 5-1

Brand	Roche
Model	cobas p 512
Category	Analytical Instruments
Language	English

Roche cobas p 512 User Manual

Table of Contents

Questions and Answers:

Roche cobas p 512 Specifications

Related product manuals