Roche Diagnostics
34 Operator’s Manual · Version 3.0
2 Installation Multiplate® analyzer
Setting up the software
Setting up the software
The following sections provide some useful information on what software to run and
not to run on this analyzer and how to integrate it into the Windows environment.
Recommendations and limitations
The analyzer is delivered with pre-installed software. The customer should consult
their Roche Service representative regarding specific circumstances that are not
mentioned, or if some points are unclear.
The hardware has been designed to provide appropriate resources for the software.
Simultaneous performance of other software may interfere with the correct function
of the software.
Due to the enormous amount of software applications available it is impossible for
Roche to validate the impact of all software that could be installed on the analyzer.
Software installation on the analyzer must therefore be restricted to tools required,
and must follow the guidelines described in this manual.
The USB ports may only be used to install, update and back up software and printer
drivers. Files and data that are not related to the use of the software must not be
copied or installed onto the analyzer hard disk.
The following table lists approved software programs.
Approved programs
Program Comment
Adobe Reader
IrfanView During the installation IrfanView offers various tools from Google. They
should not be installed.
PDF Creator Before the installation of a new version the old version must be removed
using Control Panel > Programs and Features.
During the installation, PDF Creator offers various tools. They must not
be installed.
Table 2-1 Approved programs and associated constraints
To Next Page
Loading...
