Roche Diagnostics
Operator’s Manual · Version 3.0 51
Multiplate® analyzer 2 Installation
Installing the printer
A test page is printed on the printer.
11
The window displayed next depends on your printer and driver type.
o Confirm the final printer installation window by choosing the OK button.
or,
o The window displays options like Return & Recycling or an information is
displayed, telling you that the setup is now complete.
s
p To troubleshoot printer installation
1
If no test page is printed, shut down the system and try to print again from any
Windows application.
Printing from the software works only after the printer post-installation
procedure was followed. For details, see Printer post-installation (p. 51).
2
If you cannot get the printer to work, uninstall the printer driver and any printer
related software and install the printer again from scratch.
s
Printer post-installation
p To customize printer properties
q
By default the printer driver regularly shows a pop-up window that advises the user to buy
toner cartridges. This behavior can be disabled in the printer properties.
1
Open the printer queue by selecting the printer from the menu Star t > Devices
and printers > HP L aserJet …
2
Within the printer queue window select Printer > Proper ties.
3
Within the properties window, select the Device Settings tab, set Status Messages
to Off, and choose the OK button to close the window.
4
Choose Start > Log off.
Confirm the log off in the next window by choosing the Yes button.
5
Now log on again as operator.
u For details, see Passwords for operating system (p. 149)
s
p To select the installed printer
1
Choose Print > Select printer.
Figure 2-34
To Next Page
Loading...
