Rohde & Schwarz R&S SGS100A - Page 120

Signal generator settings
R&S
®
SGS100A
120User Manual 1173.9105.02 ─ 13
The "Overview" tab shows the list of detected sensors, and provides a separate tab
per sensor.
A sensor tab contains all parameters for configuring the sensor settings, like aver-
age or peak display, reference source, filter and level offset.
The remote commands required to define these settings are described in Chap-
ter 13.12, "SENSe, READ, INITiate and SLISt subsystems", on page 245, including
the triggering of the measurement and the retrieval of measurement results.
Settings:
Sensor type and serial number................................................................................... 121
Level (Peak) / Level (Average)....................................................................................121
Sensor Mapping..........................................................................................................121
Sensor Settings...........................................................................................................121
└ State..............................................................................................................121
└ Zero...............................................................................................................121
Level and power-on settings