Rohde & Schwarz R&S SGS100A - Instruments:gpib:address; Instruments:gpib:board; Instruments:mapping:file; Instruments:name

Understanding the R&S SGMA-GUI software
R&S
®
SGS100A
87User Manual 1173.9105.02 ─ 13
:INSTruments:GPIB:ADDRess <Serial>
Sets the GPIB address of the connected instrument.
Parameters:
<Serial> List of Numbers
Example: See Example "Configuring SGMA instruments" on page 85.
Manual operation: See "GPIB Address" on page 66
:INSTruments:GPIB:BOARd
<Board>
Identifies the GPIB bus card the controller uses.
Parameters:
<Board> List of Numbers
Example: See Example "Configuring SGMA instruments" on page 85.
Manual operation: See "Board Number" on page 67
:INSTruments:MAPPing:FILE <File>
Saves the list of the available instruments in a mapping file. Mapping files are stored
with the predefined file extension .map; the file extension may be omitted.
The file is saved in the default directory. Use the command MMEM:CDIRectory to
change the default directory or specify the complete path.
Parameters:
<File> string
Example: See Example "Evaluating scan results" on page 84.
Manual operation: See "Export" on page 63
:INSTruments:NAME <Name>
Selects the alias name of the instruments, i.e. sets the "Symbolic Name".
Parameters:
<Name> <SymbolicNameInstr#1>,<SymbolicNameInstr#2>,...
Example: See Example "Searching for SGMA instruments" on page 84.
Manual operation: See "Available Instruments" on page 62
See "Symbolic Name" on page 65
:INSTruments:REMote:CHANnel <Channel>
Sets the hardware interface used by the remote channel.
Remote control of R&S SGMA-GUI