Signal generator settings
R&S
®
SGS100A
112User Manual 1173.9105.02 ─ 13
Since the settings are interdependent, the affected parameters change accordingly if
you set a value.
To fill the table, press the "Execute" button.
To select the sensor and determine its parameters, refer to Chapter 9.5.8.3, "NRP
power viewer", on page 117.
Fill User Correction Data with Sensor
●
"Sensor"
Displays connected sensors for selection.
●
"List To Fill"
Indicates the used list.
●
"Include Zeroing"
Performs a zeroing procedure before acquiring the user correction data to improve
precision. Since during zeroing no signal can be applied to the sensor, RF is tem-
porarily switched off at the generator.
When unchecked, the zeroing procedure is skipped. However, the RF signal level
can be blanked shortly. This setting is recommended if blanking of RF is undesira-
ble or the absence of power at the sensor cannot be guaranteed.
●
"Execute"
The "Execute" button is only enabled if a sensor is detected and the user correction list
contains at least one frequency value.
Remote command:
[:SOURce<hw>]:CORRection:ZERoing:STATe on page 269
[:SOURce<hw>]:CORRection:CSET:DATA[:SENSor<ch>][:POWer]:SONCe
on page 264
Used Instrument Settings For Measurement
Displays the settings relevant for the measurement.
"Modulation"
Indicates the modulation state
"Amplitude"
Shows the currently set level.
"Use SParameter"
Indicates whether SParameter correction is used.
"Attenuator Mode"
Displays the selected mode of the attenuator.
"Fixed range (PEP) In"
Shows the level range.
Remote command:
n.a.
9.5.8 Using power sensors
The R&S SGS works with most of the R&S NRP power sensors and thus supports var-
ious application tasks. Using power sensors, you can for example determine attenua-
tion characteristics of downstream equipment or cables. You can use the measured
Level and power-on settings
To Next Page
Loading...
