Rohde & Schwarz R&S SGS100A - System:mmemory:path:user; System:osystem; TEST Subsystem

Remote control commands
R&S
®
SGS100A
301User Manual 1173.9105.02 ─ 13
Suffix:
<dir>
.
1..2
Defines the section: 1 = hardware, 2 = software.
Return values:
<Name> string
Example: See Chapter 13.1.1, "Performing general tasks for instrument
setup", on page 213.
Usage: Query only
Manual operation: See "Hardware / Software/WinIQSIM" on page 146
:SYSTem:MMEMory:PATH:USER?
Queries the user directory, that means the directory the instrument stores user files on.
Return values:
<PathUser> string
Example:
SYSTem:MMEMory:PATH:USER?
Response: "/var/sgs/"'
Usage: Query only
:SYSTem:OSYStem?
Queries the operating system of the instrument.
Return values:
<OperSystem> string
Example:
SYSTem:OSYStem?
Response: "Linux"
Usage: Query only
13.22 TEST subsystem
The TEST system contains the commands for performing the routines and for direct
manipulation of the hardware assemblies (:TEST:DIRect).
The self tests return a "0" if the test is performed successfully, otherwise a value other
than "0" is returned. None of the commands of this system have an *RST value.
TEST subsystem