Rohde & Schwarz R&S SGS100A - Example; Status:operation:condition; Status:operation:enable

Remote control commands
R&S
®
SGS100A
285User Manual 1173.9105.02 ─ 13
*RST on page 223 has no effect on the status registers.
Value ranges
●
Queries return the current value of the respective register, which permits a check of
the device status.
Return values: A decimal value in the range 0 to 32767 (=2
15
-1)
●
The configuration commands set the respective register thus determining which
status changes of the R&S SGS cause the status registers to be changed.
Setting values: A decimal value in the range 0 to 32767 (=2
15
-1)
:STATus:OPERation:CONDition?.....................................................................................285
:STATus:OPERation:ENABle...........................................................................................285
:STATus:OPERation[:EVENt]...........................................................................................286
:STATus:OPERation:NTRansition.................................................................................... 286
:STATus:OPERation:PTRansition.....................................................................................286
:STATus:PRESet............................................................................................................286
:STATus:QUEStionable:CONDition.................................................................................. 287
:STATus:QUEStionable:ENABle.......................................................................................287
:STATus:QUEStionable[:EVENt]...................................................................................... 287
:STATus:QUEStionable:NTRansition................................................................................287
:STATus:QUEStionable:PTRansition................................................................................ 288
:STATus:QUEue[:NEXT]?................................................................................................288
:STATus:OPERation:CONDition?
Quieries the content of the CONDition part of the STATus:OPERation register.
This part contains information on the action currently being performed in the instru-
ment. The content is not deleted after being read out because it indicates the current
hardware status.
Return values:
<Condition> string
Example:
:STATus:OPERation:CONDition?
Usage: Query only
:STATus:OPERation:ENABle <Enable>
Sets the bits of the ENABle part of the STATus:OPERation register. This setting deter-
mines which events of the Status-Event part are forwarded to the sum bit in the status
byte. These events can be used for a service request.
Parameters:
<Enable> string
Example:
:STAT:OPER:ENAB 32767
all events are forwarded to the sum bit of the status byte.
STATus subsystem