System overview
R&S
®
SGS100A
52User Manual 1173.9105.02 ─ 13
9. Select "Test Signal Connections > Test" to trigger a check of all required signal
connections.
The diagram displays the connection state of the tested signal connections. If the
test connections are correct (shown by an uninterrupted blue line), you can start
using the R&S SGS and the R&S SGU in extension mode.
Tip: If your connection is marked as faulty, check whether the cables are connec-
ted properly. Check also if the connection cables are functioning properly.
Figure 7-6: A faulty connection between an R&S SGU and an R&S SGS
7.2.3 Connecting via a PCIe switch
The R&S SGS and the R&S SGU can be connected through a PCIe switch as shown
in Figure 7-7. This setup is recommended for achieving the highest setting/ measuring
speeds.
Connecting an R&S SGS and an R&S SGU
To Next Page
Loading...
