Rohde & Schwarz R&S SGS100A - Connecting to a Company Network

System overview
R&S
®
SGS100A
49User Manual 1173.9105.02 ─ 13
For a direct PCIe connection, an automatic identification of the R&S SGU as an exten-
sion is only available for an R&S SGS with a " Controller > Revision" 5 or higher. For a
description on how to set the PCIe identification manually, see Chapter 11.14, "How to
set a PCIe direct connection", on page 174.
You can check the "Controller > Revision" of your instrument in the "SGMA-GUI >
Instrument Name > Hardware Config" dialog.
If instrument is not automatically added as an extension
You can do that manually in the "SGMA-GUI > R&S SGS Name > Extension" dialog.
If the R&S SGU is not listed in the list of "Available Instruments", you can press "Scan
> Start" to find the instrument.
7.2.2 Connecting to a company network
This step-by-step instruction describes how to connect an R&S SGS and an R&S SGU
in a company network. As a prerequisite for this example the R&S SGMA-GUI software
has to be installed on a remote PC.
Connecting an R&S SGS and an R&S SGU