Rohde & Schwarz R&S SGS100A - How to Switch between Operating States

Performing configuration tasks
R&S
®
SGS100A
169User Manual 1173.9105.02 ─ 13
11.9 How to switch between operating states
The Figure 11-4 gives an overview of the operating states of the instruments and how
to trigger the switch-over between them.
Figure 11-4: Operating states
:RESTart, :STANdby = SCPI commands
"Setup" > "Standby", "Setup" > "Restart", "Shut Down Instru-
ments and Exit"
= R&S SGMA-GUI controls
[POWER ON/STANDBY], power switch [ I/0] = Hardkey controls on the front/rear panel of
the instrument
The Table 11-2 provides a short description of the operating states and their indication.
Table 11-2: Indication of the operating states
Operating
state
Description Indication
Off The instrument is shut down. All LEDs on the front panel of the instrument
are off.
Booting The instrument boots the operating system
and starts the instrument firmware.
If the previous session was terminated reg-
ularly, the instrument uses the last setup
with the relevant instrument settings.
The green [POWER ON/STANDBY] key blinks.
How to switch between operating states