Rohde & Schwarz R&S SGS100A - Diagnostic and Tests; Selftest; Standby and Restart

General instrument settings and instrument setup
R&S
®
SGS100A
157User Manual 1173.9105.02 ─ 13
10.11 Standby and restart
See Chapter 11.9, "How to switch between operating states", on page 169.
10.12 Diagnostic and tests
This section describes the settings provided for diagnostic and test purposes.
Access:
► Select "SGMA-GUI > Instrument Name > Setup > Diagnostic / Test".
The selection provides the following settings.
Settings
● Selftest.................................................................................................................. 157
● Keyboard tests...................................................................................................... 158
10.12.1 Selftest
Access:
1. Select "SGMA-GUI > Instrument Name > Diagnostic Tests > Self-test".
2. To trigger a self-test, select "Self-test".
Performs a self test on all installed hardware options.
The result of the self-test, succeeded or failed, is displayed. The list of the numeric
results of the performed test cases is protected by protection level 2.
SCPI command:
:TEST:ALL:STARt on page 302
Diagnostic and tests