Rohde & Schwarz R&S SGS100A - Sense, READ, Initiate and Slist Subsystems

Remote control commands
R&S
®
SGS100A
245User Manual 1173.9105.02 ─ 13
Example: See Chapter 13.1.4, "Advanced tasks to optimize performance",
on page 218.
Manual operation: See "Power-On State" on page 103
:OUTPut[:STATe] <State>
Activates/ deactivates the RF output.
Parameters:
<State> 1 | ON | 0 | OFF
Example: See Chapter 13.1.2, "Generating an I/Q modulated signal",
on page 215.
Manual operation: See "RF On/Off" on page 73
13.12
SENSe, READ, INITiate and SLISt subsystems
These subsystems contain the commands for configuring the power measurements
with R&S NRP power sensor connected to the R&S SGS.
The local state is set with the INIT command. Switching off the local state enhances
the measurement performance. Measurements results can be retrieved in local state
on or off.
Sensor parameters are set with the SENSe commands.
To start the measurement and retrieve the result, use the :READ<ch>[:POWer]?
command.
Suffix Value range Description
SENSe<ch>
[1] to 4 Indicates the sensor
Use the :SLISt commands to change the sensor mapping
READ<ch>
[1] to 4 Sensor assignment
INIate<hw>
[1] to 4 Sensor assignment
ELEMent<ch>
[1] to 25 Sensor-mapping list
SENSe, READ, INITiate and SLISt subsystems