Rohde & Schwarz R&S SGS100A - Default Network Settings; LXI Browser Settings

Network operation and remote control
R&S
®
SGS100A
202User Manual 1173.9105.02 ─ 13
12.6.1 Default network settings
According to the LXI standard, an LCI must set the following parameters to a default
state.
Parameter Value
TCP/IP mode DHCP + Auto IP Address
Dynamic DNS Enabled
ICMP ping Enabled
Password for LAN configuration LxiWebIfc
The LAN reset also resets the following parameters for the R&S SGS:
Parameter Value
Hostname <Instrument-specific host name>
Description Signal generator
Negotiation Auto detect
VXI-11 discovery Enabled
The LAN settings are configured using the instrument's LXI browser settings.
12.6.2 LXI browser settings
You can access LXI borowser settings via a web browser.
Access:
► Type in the instrument's host name or IP address in the address field of the
browser on your PC, for example "http://10.111.0.125".
Note: Do not add the missing zeros in the IP address, while opening the instru-
ment home page.
LXI configuration