Rohde & Schwarz R&S SGS100A - Install SW Options; Protection

General instrument settings and instrument setup
R&S
®
SGS100A
147User Manual 1173.9105.02 ─ 13
For R&S SGMA-GUI, the list shows the open-source acknowledgement for software
with Windows
®
operating system.
For R&S SGU/SGS/SGT, the list shows the open-source acknowledgement for soft-
ware with Linux
®
operating system.
LucasFonts RSCorpid EULA
Accesses copyright information on LucasFonts font type RSCorpid EULA.
10.4 Install SW options
Newly purchased software options are enabled in the "Install SW-Option" dialog. They
are ready to operate after they are enabled by a key code supplied with the option.
Only if the instrument is equipped with an older firmware version, a firmware update
before enabling the software option can be required. The information on the valid firm-
ware versions for the purchased software option is provided together with the option.
See:
●
Chapter 11.12, "How to install a new firmware version on the instrument",
on page 172 for information on how to perform firmware update
●
Chapter 11.13, "How to activate options", on page 174 for instruction on how to
install new options
The firmware update is also described in the service manual.
10.5 Protection
The "Protection" dialog provides access to the unlocking of protected service functions
(authorized personnel of R&S service departments only).
Unlocking protected service functions
1. Select "SGMA-GUI main panel > Instrument Name > Setup > Protection".
The "Protection" dialog provides access to the unlocking of protected service func-
tions (authorized personnel of R&S service departments only).
2. To deactivate the protection, enter the correct password. After booting the instru-
ment, protection levels 1 to 4 are active.
Enter "Protection Level 1 > Password > 123456".
Protection Level 1 is activated.
Protection