Rohde & Schwarz R&S SGS100A - Instruments:clear; Instruments:count; Instruments:eaccess[:State]

Understanding the R&S SGMA-GUI software
R&S
®
SGS100A
86User Manual 1173.9105.02 ─ 13
Parameters:
<State> List of BOOL-values
<StateInstr#1>,<StateInstr#2>,...
0, 1, ON, OFF
Example: See Example "Evaluating scan results" on page 84.
Manual operation: See "Available Instruments" on page 62
See "Active" on page 65
:INSTruments:CLEar
Clears all instruments in the device list.
Parameters:
<Count> float
Range: 0 to 12
Example: See Example "Configuring SGMA instruments" on page 85.
Usage: Event
:INSTruments:COUNt?
Queries the number of the currently available instruments.
Return values:
<Count> float
Range: 0 to 12
Example: See Example "Searching for SGMA instruments" on page 84.
Usage: Query only
Manual operation: See "Available Instruments" on page 62
:INSTruments:EACCess[:STATe] <State>
"Locks" the instruments, meaning the instrument is reserved and can be operated
exclusively from the remote PC that sent this SCPI command.
Tip: It is recommended to lock the instrument prior to further configuration.
Parameters:
<State> List of BOOL-values
<LockInstr#1>,<LockInstr#2>,...
0,1,OFF,ON
Example: See Example "Evaluating scan results" on page 84.
Manual operation: See "Exclusive Access" on page 66
Remote control of R&S SGMA-GUI