Rohde & Schwarz R&S SGS100A - UNIT Subsystem

Remote control commands
R&S
®
SGS100A
302User Manual 1173.9105.02 ─ 13
Improper use can destroy the assembly
The respective hardware assembly responds directly to the :TEST:DIRect command;
any safety mechanisms are bypassed. The command is intended for servicing purpo-
ses and should be used only by the Rohde & Schwarz service personnel.
:TEST:ALL:STARt...........................................................................................................302
:TEST:ALL:RESult?........................................................................................................302
:TEST:KEYBoard[:STATe]............................................................................................... 302
:TEST:ALL:STARt
Starts the selftest. Use the command :TEST:ALL:RESult? to query the result.
Example:
See Chapter 13.1.1, "Performing general tasks for instrument
setup", on page 213.
Usage: Event
:TEST:ALL:RESult?
Queries the result of the performed selftest. Start the selftest with :TEST:ALL:STARt.
Return values:
<Result> 0 | 1 | RUNning | STOPped
*RST: STOPped
Example: See Chapter 13.1.1, "Performing general tasks for instrument
setup", on page 213.
Usage: Query only
:TEST:KEYBoard[:STATe] <State>
Enable/disable keyboard and LED test state.
Parameters:
<State> 1 | ON | 0 | OFF
13.23 UNIT subsystem
The UNIT subsystem contains the commands specifying which units are valid if no unit
is indicated in a command. These settings are valid for the entire instrument.
:UNIT:ANGLe <Angle>
Sets the default angle unit for remote control. Does not influence the manual control
parameter units and the display.
UNIT subsystem