Rohde & Schwarz R&S SGS100A - Diagnostic Subsystem

Remote control commands
R&S
®
SGS100A
230User Manual 1173.9105.02 ─ 13
:CONNector:REFLo:OUTPut <Output>
Determines the signal provided at the output connector [REF/LO OUT] (rear of the
instrument).
Parameters:
<Output> REF | LO | OFF
*RST: REF
Manual operation: See "REF/LO Output" on page 95
:CONNector:TRIGger:OMODe
<Mode>
Sets the operating mode of the trigger connector.
The parameters PVOut|PETRigger|PEMSource are available only with option
R&S SGS-K22.
Parameters:
<Mode> SVALid | SNValid | PVOut | PETRigger | PEMSource
SVALid|SNValid
signal valid /not valid
PVOut
pulse generator video out
PETRigger
pulse generator external trigger
PEMSource
external pulse modulator source
Manual operation: See "Trigger Connector Mode" on page 128
13.7 DIAGnostic subsystem
:DIAGnostic:POINt:CATalog?...........................................................................................230
:DIAGnostic[:MEASure]:POINt?.......................................................................................231
:DIAGnostic:POINt:CATalog?
Queries the test points available in the instrument.
For description of the test points, see the service manual.
Example:
See Chapter 13.1.1, "Performing general tasks for instrument
setup", on page 213.
Usage: Query only
DIAGnostic subsystem