Rohde & Schwarz R&S SGS100A - Setup Menu

Understanding the R&S SGMA-GUI software
R&S
®
SGS100A
61User Manual 1173.9105.02 ─ 13
Shut down instruments and exit
Quits the R&S SGMA-GUI and switches the connected instruments to the standby
state (see also Chapter 11.9, "How to switch between operating states", on page 169).
8.1.2 Setup menu
Access:
► Select "SGMA-GUI > Setup"
The setup menu provides access to dialogs for setting the general settings of the
software, like dialogs for managing the connected instruments or dialogs providing
information about the installed options.
Settings
● Configure instruments.............................................................................................61
● Add/Edit instruments...............................................................................................65
● Software..................................................................................................................67
● Reset SGMA-GUI....................................................................................................68
● Protection................................................................................................................68
● Remote....................................................................................................................69
8.1.2.1 Configure instruments
This dialog is the central point for managing the instrument that is configured and oper-
ated via the R&S SGMA-GUI. New instruments can be created and appended to the
list of available instruments. Connection settings can be edited, instruments can be
removed from the list or they can be deactivated, but kept in the list for further use.
Operating menu and toolbar