Understanding the R&S SGMA-GUI software
R&S
®
SGS100A
68User Manual 1173.9105.02 ─ 13
Show Open Source Acknowledgments
Accesses the list of the used open source software packages and the corresponding
verbatim license texts.
Versions
Shows the installed software platform and its version.
8.1.2.4 Reset SGMA-GUI
Resets R&S SGMA-GUI to its factory preset settings.
The connected instruments are not affected by this preset.
To preset one specific instrument to its factory preset settings, select "SGMA-GUI >
Instrument Name > Setup > Factory Preset". Refer to Chapter 10.9, "Factory preset",
on page 155 for an overview of the settings affected by this function.
8.1.2.5 Protection
The "Protection" dialog provides access to the unlocking of protected service functions
(authorized personnel of Rohde & Schwarz service departments only).
Unlocking of protected service functions
1. Select "SGMA-GUI > Setups > Protection".
After the instrument has been switched on, the protection levels 1 to 4 are auto-
matically activated.
2. To deactivate the protection, enter the correct password.
Enter "Protection Level 1 > Password > 123456".
Protection Level 1 is activated.
Operating menu and toolbar
To Next Page
Loading...
