Rohde & Schwarz R&S SGS100A - Slist:clear:lan; Slist:clear:usb; Slist:scan:usensor

Remote control commands
R&S
®
SGS100A
249User Manual 1173.9105.02 ─ 13
Setting parameters:
<IP> string
*RST: 0
Example: See Example "Detecting and assigning a power sensor"
on page 246.
Usage: Setting only
Manual operation: See "Add LAN Sensor settings" on page 117
:SLISt:SCAN:USENsor
<DeviceID>, <Serial>
Scans for R&S NRP power sensors connected over a USB interface.
Parameters:
<Serial> integer
Range: 0 to 999999
Setting parameters:
<DeviceID> String or Integer
Range: 0 to 999999
*RST: 0
Example: See Example "Detecting and assigning a power sensor"
on page 246.
Usage: Setting only
Manual operation: See "Add USB Sensor settings" on page 117
:SLISt:CLEar:LAN
Removes all R&S NRP power sensors connected in the LAN from the list.
Example:
See Example "Detecting and assigning a power sensor"
on page 246.
Usage: Event
Manual operation: See "Clear" on page 116
:SLISt:CLEar:USB
Removes all R&S NRP power sensors connected over USB from the list.
Example:
See Example "Detecting and assigning a power sensor"
on page 246.
Usage: Event
Manual operation: See "Clear" on page 116
SENSe, READ, INITiate and SLISt subsystems