Network operation and remote control
R&S
®
SGS100A
185User Manual 1173.9105.02 ─ 13
Basic knowledge of programming and operation of the controller are assumed. A
description of the interface commands can be obtained from the relevant manuals.
Refer to the getting started manual for an example of how to set up remote control con-
nection over LAN using VXI-11 protocol.
To set up a Telnet connection
To control the software, only a telnet program is required. The telnet program is part of
every operating system.
1. To establish a Telnet connection with the R&S SGS, start the telnet program.
2. Enter the socket address.
The socket address is a combination of the IP address or the host name of the
R&S SGS and the number of the port configured for remote-control via telnet.
Tip: The R&S SGS uses the port number 5025 for remote connection via Telnet.
The connection to the instrument is set up and remote-control commands can be
sent.
3. Even if the cursor is not visible on the screen, enter blind a remote-control com-
mand.
4. Confirm with "Enter".
Starting a remote control session
To Next Page
Loading...
