Rohde & Schwarz R&S SGS100A - Page 262

Remote control commands
R&S
®
SGS100A
262User Manual 1173.9105.02 ─ 13
[:SOURce<hw>]:CORRection:DEXChange:SELect............................................................268
[:SOURce<hw>]:CORRection:CSET[:SELect]................................................................... 268
[:SOURce<hw>]:CORRection[:STATe]..............................................................................269
[:SOURce<hw>]:CORRection:VALue?..............................................................................269
[:SOURce<hw>]:CORRection:ZERoing:STATe.................................................................. 269
[:SOURce]:CORRection:CSET:CATalog?
Requests a list of user correction tables. The individual lists are separated by commas.
The lists are stored with the fixed file extensions *.uco in a directory of the user's
choice. The directory applicable to the commands is defined with the command
MMEMory:CDIR.
Return values:
<Catalog> string
Example:
MMEM:CDIR '/var/sgs/ucor'
selects the directory for the user correction files.
CORR:CSET:CAT?
queries which correction tables are available.
Response:UCOR1,UCOR2,UCOR3
the correction tables UCOR1, UCOR2 and UCOR3 are availa-
ble.
Usage: Query only
[:SOURce<hw>]:CORRection:CSET:DATA:FREQuency <Frequency>
Transfers the frequency data to the table selected with :CORRection:CSET:SELect.
The numerical suffix at SOURce must not be used for this command.
Parameters:
<Frequency> Frequency#1[, Frequency#2, ...]
Range: 300 kHz to RFmax (depending on model)
Example:
CORR:CSET '/var/sgs/ucor1'
selects the table ucor1.
CORR:CSET:DATA:FREQ 100MHz,102MHz,103MHz,...
enters the frequency value in the table ucor1.
Manual operation: See "Edit User Cor. Data" on page 106
[:SOURce<hw>]:CORRection:CSET:DATA:FREQuency:POINts?
Queries the number of frequency values in the selected table.
The numerical suffix at SOURce must not be used for this command.
SOURce:CORRection subsystem