Rohde & Schwarz R&S SGS100A - Page 283

Remote control commands
R&S
®
SGS100A
283User Manual 1173.9105.02 ─ 13
Example: See Chapter 13.1.4, "Advanced tasks to optimize performance",
on page 218.
Manual operation: See "Ext. Ref. Input Frequency" on page 96
[:SOURce]:ROSCillator:OUTPut:FREQuency <OutputFreq>
Selects the output for the reference oscillator signal.
Parameters:
<OutputFreq> 10MHZ | 100MHZ | 1000MHZ | 13MHZ
13MHZ requires RF board with part number 1419.5308.02.
Example: See Chapter 13.1.4, "Advanced tasks to optimize performance",
on page 218.
Manual operation: See "Output Frequency" on page 97
[:SOURce]:ROSCillator:SOURce <Source>
Select the reference oscillator signal source.
Parameters:
<Source> INTernal | EXTernal
Example: See Chapter 13.1.2, "Generating an I/Q modulated signal",
on page 215.
Manual operation: See "Ref. Oscillator Source/Ext Ref On/Off" on page 74
[:SOURce]:ROSCillator[:INTernal]:ADJust:VALue <Value>
Allows an application to shift the reference oscillator frequency by a small amount.
The setting range depends on the reference oscillator type and its factory calibration
value. Allowed are the following ranges:
●
For TCXO oscillator: Max - Min = 1023
●
For OCXO oscillator: Max - Min = 65535 (option R&S SGS-B1 required.)
Parameters:
<Value> integer
Range: Min to Max
*RST: 0
Example: See Chapter 13.1.4, "Advanced tasks to optimize performance",
on page 218.
Manual operation: See "DAC Value" on page 98
SOURce:ROSCillator subsystem