Preparing for use
R&S
®
SGS100A
32User Manual 1173.9105.02 ─ 13
4. Enter the "Subnet mask", for example 255.255.255.0.
5. Enter the "Default Gateway", for example 192.168.0.1.
Assigning a static IP address to your Windows-PC network card
1. Obtain the IP address and subnet mask for the R&S SGS and the IP address for
the local default gateway from your network administrator. If necessary, also obtain
the name of your DNS domain and the IP addresses of the DNS and WINS servers
on your network. If you use more than one LAN connector, you need separate
address information for each connector.
2. Press the "Windows" key to access the operating system.
3. Open the "Control Panel" by selecting "Start > Settings > Control Panel".
4. Select "Network and Sharing Center".
5. In the left panel, click "Change adapter settings".
6. Select the network adapter that you want to change. Click "Change settings of this
connection".
7. On the "Networking" tab, click "Internet Protocol Version 4 (TCP/IPv4)". Select
"Properties".
8. Select "Use the following IP address".
9. Enter the address information as obtained from the network administrator.
10. If necessary, you can also select "Use the following DNS server addresses" and
enter your own DNS addresses.
For more information, refer to your Windows system help.
3.13.2.3 Adding instruments to R&S SGMA-GUI
For information on how to install the R&S SGMA-GUI software, refer to Chapter 3.13.1,
"Installing the R&S SGMA-GUI software", on page 28.
1. For each new instrument perform the following steps:
a) Connect the instrument to the network.
b) Press the [POWER ON/STANDBY] key to switch on the instrument.
c) Wait until the [POWER ON/STANDBY] LED is green and not blinking.
d) Press the [ID] key on the front panel of the instrument.
2. Start the SGMA-GUI on a computer connected to the same network.
3. Open the "Instruments" dialog.
4. Select "Scan".
Connecting an external PC and devices
To Next Page
Loading...
