Rohde & Schwarz R&S SGS100A - Page 38

Instrument tour
R&S
®
SGS100A
38User Manual 1173.9105.02 ─ 13
LAN
RJ-45 connector to connect the R&S SGS to a LAN for remote control.
How to:
●
Chapter 3.7, "Connecting to LAN", on page 23
●
Chapter 3.13.2, "Connecting a remote PC via LAN", on page 30
PCIe
PCIe (Peripheral Component Interconnect Express) single lane interface for remote
control with optimized speed.
How to: Chapter 12.3.4, "Connecting the controller and the instrument", on page 190.
USB In
USB (universal serial bus) type Micro-B connector for remote control via various exter-
nal devices.
How to: Chapter 3.13.4, "Connecting a controller via USB", on page 33
RF 50Ω
SMA female connector for output of the RF signal.
How to: Chapter 3.8, "Connecting to RF 50Ω", on page 23
LO IN, LO OUT, REF IN, REF OUT
SMA female type connectors, for reference or local oscillator signals, and alternatively
also in MIMO setups.
Reference input and output:
●
"REF IN": Input for external reference signal.
●
"REF OUT": Output of internal reference signal.
Local oscillator input/output requires R&S SGS-K90.
Local oscillator input and output connectors:
●
"LO IN": Input for external LO signals
●
"LO OUT": Output of internal LO signals.
How to: "To connect to screwable connectors" on page 24
I/Q
Requires R&S SGS-B106V/-B112V.
SMA female connectors for input of external I/Q signals. The signals are fed directly
into the I/Q modulator.
How to: "To connect to screwable connectors" on page 24
TRIG
SMA female multipurpose connector for input and output signals, e.g., for the following
signals: "Trigger", "Marker 1/2", "Clock In/Out", "Sync In/Out".
Also, use the "TRIG" connector for input of an external pulse modulator signal.
How to: "To connect to screwable connectors" on page 24
Rear panel tour