Trying out the Instrument
R&S
®
SGS100A
40User Manual 1173.9105.02 ─ 13
3. In the R&S SGMA-GUI main panel, the green indicator in front of the instrument's
name confirms that there is a connection between the instrument and the remote
PC and that the instrument is recognized by the software.
4. In the R&S SGMA-GUI main panel, select the row corresponding to the instrument
to be configured and select "Instrument Name > Preset" to restore the predefined
instrument's settings.
5. In the R&S SGMA-GUI main panel, select the row corresponding to the instrument
to be configured and adjust the "Frequency" as required.
6. Select "SGMA-GUI > RF On" to enable the output of the CW signal.
The 5 GHz signal is output at the "RF 50Ω" connector at the rear panel of the
R&S SGS.
Configuring a CW Signal with the R&S SGMA-GUI
To Next Page
Loading...
