Understanding the R&S SGMA-GUI software
R&S
®
SGS100A
81User Manual 1173.9105.02 ─ 13
Dialog "Edit Instrument" does not appear
If this dialog does not open, perform the following:
●
Check whether the instrument is correctly connected to the external PC on which
you work with the R&S SGMA-GUI.
●
Check if the instrument is configured in the R&S SGMA-GUI and perform, if neces-
sary, the steps described in Chapter 8.4.2, "Handling instruments in the R&S
SGMA-GUI", on page 75.
●
Select "SGMA-GUI > Setup > Instruments", check the state of the instrument in the
"Configure Instruments > Available Instruments" table and activate it, if disabled.
How to identify an instrument in an instrument set
1. To identify the instrument in an instrument set, use one of the device identification
functions:
● Select "SGMA-GUI > Setup > Instruments > Available Instruments > Instrument
> Edit > Edit Instrument".
● Select "SGMA-GUI > Instrument Name > Setup > Remote > Remote Chan-
nels".
● Select "SGMA-GUI > Instrument Name > Setup > LXI Status".
Working with R&S SGMA-GUI
To Next Page
Loading...
