BRP-Rotax
REPAIR MANUAL
PROCESS ADVICE
Safety note
m WARNING
Non-compliance can result in serious injuries or death!
When carrying out maintenance and service work, respect without fail the safety
regulations.
Ignition “OFF”
m WARNING
Non-compliance can result in serious injuries or death!
This precautionary measure serves to avoid any injuries in case of an unintentional start
of the engine. Principally ensure the following at each maintenance event:1.) Ignition
“OFF“ and system grounded, 2) Disconnect battery and secure engine against uninten-
tional operation.
Handling of fluids
m WARNING
Non-compliance can result in serious injuries or death!
Non-compliance with this instruction may cause severe burns or scalding! Hot engine
parts! Always allow the engine to cool down to ambient temperature before starting
work.
At maintenance of cooling-, lubricating and fuel system take care without that no contami-
nation, metal chips, foreign material and/or dirt enters the system.
Disassembly At disassembly of the engine, mark the components as necessary to avoid any mix-up.
Take care of these marks, do not ruin them.
Tool
ATTENTION
In order to avoid mechanical damages, never loosen or tighten screws and nuts with pli-
ers but only with the specified tools.
Safety wiring
ATTENTION
If during diassembling/reassembling the removal of a safety item (e.g. safety wiring,
self-locking fastener, etc.) should be necessary, it must be always replaced by a new
one.
Chapter 2
Page 4
Effectivity: 125 MAX evo, Junior MAX
evo, Mini MAX evo, Micro MAX evo
Edition - February 01 2018 /Rev. 0
To Next Page
Loading...
Need help?
General
