BRP-Rotax
REPAIR MANUAL
Cleaning of parts
ATTENTION
All metal and synthetic parts are generally washed with suitable cleaning agents. Be-
fore using new and unknown cleaning agents check the compatibility of materials.
Removed parts Before re-using disassembled parts, clean, check and refit them as per instructions.
Use clean screws and nuts only and inspect face of nuts and thread for damage. Check
the contact faces and threads for damages. In case of doubt, use new screws and nuts
Measurements When making low tolerance measurements (s<0.1 mm) and in measuring bearing and
housing components, the temperature of the components and their surroundings must be
in the range 20 °C - 25 °C (68 °F – 77 °F). Only used certified measuring tools!
Nuts Once loosened, always replace self-securing nuts!
Sealing rings, O-
rings
At reassembly of the engine, replace all sealing rings, gaskets, securing elements, O-rings
and oil seals.
Re-assembly Before re-assembly check components whether parts are missing. Only use adhesives,
lubricants, cleaning agents and solvents indicated in the maintenance instructions. If not
respected, damage may be the consequence and no warranty claim.
Effectivity: 125 MAX evo, Junior MAX
evo, Mini MAX evo, Micro MAX evo
Edition - February 01 2018 /Rev. 0
Chapter 2
Page 5
To Next Page
Loading...
Need help?
General
