COMMAND RANGING & TELEMETRY UNIT CORTEX
CRT QUANTUM USER'S MANUAL
Ref. DTU 100042
Is.Rev. 5.17
Date: Dec.
03, 2021Sept. 30, 2021
This document is the property of Safran Data Systems.
It cannot be duplicated or distributed without expressed written consent.
2.3.3.1.4. Configuration S107583 : Agencies / AIT 4U with EFC
The connection of the various signals to the user system is normally performed
Directly at the rear panel for the 2 RF outputs and 3 RF inputs of the EFC board with SMA
connectors
Through the Interconnection Panel described in 2.3.1.2 for the other signals (Uplink IF Alternates,
Downlink IF Alternates, AGC out, Video out, reference frequencies and TTL signals)
The computer connections (LAN, VGA, RS232) are directly available on the Industrial Computer rear panel.
The picture below lists and identifies the various connections to the computer ports, and the I/O connectors of the
Cortex CRT Quantum dedicated hardware
Figure 15: IS00427 Rear panel Connectors with BNC integration, external I/O connectors and EFC
Note: The CRT is able to support Simple or Redundant Power Supply (Factory Option)
To Next Page
Loading...