Safran CORTEX CRT Quantum - Table 4: I;O Connector Panel

COMMAND RANGING & TELEMETRY UNIT CORTEX
CRT QUANTUM USER'S MANUAL
Ref. DTU 100042
Is.Rev. 5.17
Date: Dec. 03, 2021Sept.
30, 2021
© Safran Data Systems
This document is the property of Safran Data Systems.
It cannot be duplicated or distributed without expressed written consent.
Page 5
CONNECTOR
TYPE
CONNECTOR
PANEL
LABEL
CABLE
SLEEVE
LABEL
MSP MODULE
CONNECTOR
LABEL
SIGNAL
ELECTRICAL CHARACTERISTICS
TEST POINTS (continued)
BNC Female
AGC OUT 3
AGC OUT 3
Note 3
AGC voltage Output 1
Non coherent AGC :
significant from -20 dBm to –60 dBm,
Coherent IF level :
significant from 0 dBm to –100 dBm)
0 to 10 V, 10 dB/V
+ 2 V = -20 dBm,
+10 V = -100 dBm
Requires high impedance input
BNC Female
Sts Out/J25
to
Sts Out/J28
Note 2
I/O NUM board
Video Test Points
(see section 2.3.4.1for assignment to internal
signals)
LVTTL 50 
BNC Female
EXT 1 to EXT 6
Not supplied
Not supplied
Reserved
N/A
AZ / EL
Sub-D 25
AZ+
Not supplied
Not supplied
Azimuth Error (Antenna Tracking)
Refer to Cortex DTR User’s Manual
AZ-
EL+
Elevation Error (Antenna Tracking)
Refer to Cortex DTR User’s Manual
EL-
Table 4: I/O Connector Panel
Note 1: These signals are on a cluster of 6 miniature coacial connectors on the rear panel of the MSP module
Note 2: These signals are on a multiwire ribbon cable connected to the IONUM board located on a panel above the computer I/O connectors. Direct connection to the Samtec
multipin connector is not recommended.
Note 3: These signals are on a cluster of 10 miniature coacial connectors on the rear panel of the MSP module. For Cortex CRT applications, only 5 of the 10 connectors are
used.
Note 4: signal level can be adjusted from registry keys. See section 4.2.8.9.4