PN 9001098
Rev. A
2-5
SATO M-10e TT/DT Printers Service Manual
Section 2. Configuration
Receive Buffer Selection (DSW2-5):
This setting selects the operating mode of the receive buffer. See Section 3:
Interface Specifications for more information.
DSW2-5 SETTING
Off Single Job
On Multi-Job
123 4 56 7 8
ON
OFF
DSW2
If a 10/100BaseT LAN card is installed, DS2-5 has the following definitions.
DSW2-5 SETTING
Off ENQ Resopnse
On Periodic Response
Firmware Download (DSW2-6):
This selection places the printer in the Firmware Download mode for downloading
new firmware itno flash ROM.
123 4 56 7 8
ON
OFF
DSW2
Protocol Code Selection (DSW2-7):
This setting selects the command code used for protocol control.
DSW2-7 SETTING
Off Standard
On Non-Std
123 4 56 7 8
ON
OFF
DSW2
DSW2-6 SETTING
Off Disabled
On Enabled
To Next Page
Loading...
