PN 9001098
Rev. A
2-13
SATO M-10e TT/DT Printers Service Manual
Section 2. Configuration
STEP PROCEDURE
1. Press the LINE key while simultaneously turning ON the power. When the
printer emits one long beep, release the LINE key to display the first screen.
2. Press the ENTER key to display the Zero Slash screen.
LCD Panel —Normal Mode
Cancel Print Job
If the printer has a print job(s) loaded in memory, selecting YES will cause the job(s) to be
cleared. The default selection is NO (Do not clear). Make sure you want to clear the print job
before selecting YES as the job cannot be recovered and will have to be transmitted to the
printer.
Perform the following steps:
cancel print job
yes no
STEP PROCEDURE
1. Use the keys to step the cursor to either YES or NO.
2. Once the correct setting is selected, press the ENTER to confirm the
setting, confirms YES (Clear) or NO (Do not clear).
3. After the print job(s) have been cleared from memory, the printer
will display a COMPLETED message for 3 seconds and then return
to the initial ONLINE Normal Mode.
4. If you wish to change any of the settings, you must enter the User
mode again by taking the printer OFFLINE and simultaneously
pressing the FEED and LINE keys.
cancel print job
completed
Advanced Mode
Advanced Mode is provided to make adjustments that require only occasional adjustments.
Since they affect the basic operation of the printer, the procedure for entering this mode is
designed to prevent someone from accidentally changing the settings.
initializing
rom voo.00.00.00
advanced mode
To Next Page
Loading...
Need help?
General
