SATO M-10e TT/DT Printers Service Manual
PN 9001098
Rev. A
2-40
Section 2. Configuration
LCD Panel — Hex Dump Mode
In addition to the User Test Print Labels, the printer can print the contents of the receive
buffer in a hexadecimal format to allow the data stream to be examined for errors and
troubleshooting.
STEP PROCEDURE
1. To enter the Hex Dump mode, place DSW2-4 in the ON position and
power on the printer.
2. Send the data stream to the printer.
3. The receive data will be printed in a hexadecimal format.
4. To return the printer to normal position, place DSW2-4 in the OFF
position and power off the printer, then back on.
To Next Page
Loading...
