SATO S84NX - Page 160

[Imaging]
160
Standard/Left-Hand Type Opposite/Right-Hand Type
(1) Feed direction (1) Feed direction
The setting range varies depending on the print resolution of the product.
The setting range is as follows:
Resolution S84NX S86NX
203 dpi (1 dot = 0.125 mm
(0.0049"))
-831 to 0 to 831 dots -1339 to 0 to 1339 dots
305 dpi (1 dot = 0.083 mm
(0.0033"))
-1247 to 0 to 1247 dots -2009 to 0 to 2009 dots
609 dpi (1 dot = 0.042 mm
(0.0017"))
-2495 to 0 to 2495 dots -
• You can change the units to dots, " (inches), or mm in the [System] > [Regional] >
[Unit] menu.
Adjusting Direction of the Print Reference Position and Base Reference Point
Standard/Left-Hand Type Opposite/Right-Hand Type
(1) Feed direction
(2) Liner
(3) Label
(4) Gap between labels
(5) Print reference position (before correction)
(6) Adjustment of vertical base reference point
(7) Adjustment of horizontal base reference point
(8) Base reference point after adjustment
(1) Feed direction
(2) Liner
(3) Label
(4) Gap between labels
(5) Print reference position (before correction)
(6) Adjustment of vertical base reference point
(7) Adjustment of horizontal base reference point