[Advanced]
176
[Extended Backfeed Operation]
Enable or disable the extended backfeed operation.
Appears if you have selected [Dispenser] in the [Print Mode] menu as well as selecting [Before] in the
[Backfeed] menu.
By enabling this function, when using the external signal (EXT) interface, print data is received and at
the stage that printing becomes possible, then backfeed is done and it waits for input of the Print Start
signal (PRIN).
[Page Clipping Mode]
Enable or disable the page clipping mode.
By enabling the page clipping mode, printing cuts off outside print areas as a separation at the print
positions.
The print position moves according to the values set in the [Pitch] or [Pitch Offset] in the [Printing] >
[Advanced] > [Adjustments] menu.
The figure below shows the state with no print position adjustment (±0) when the Gap sensor is used.
Disabled
If print data (1) goes past the print position (b), then the next printing is done at print position (c).
Printing is done at print position (b), so it is excluded from being a reference position because it is
a position where printing and dispensing-stop cannot be done.
To Next Page
Loading...