177
Enabled
Print data (1) stops printing at print position (b). The next printing is done from print position (b).
• Do not design label layouts so that important information, such as barcodes, 2D codes,
or prices, adjacent to where labels are separated.
We recommend using this function to check the results of printing as much as possible,
such as barcode reading and image verification.
• Do not create designs that position items that are not printed on the label in print-
positions that are not on the label.
They will be printed on the label by printers other than this printer or if the label is large.
Also, in some cases, on subsequent models with different functions, commands may
no longer be usable.
• This function basically operates by using a media sensor to detect where labels are
separated. If labels are skewed (fed too little, fed too much, backfed too little) as they
feed, then unwanted operations may occur, such as printing cutting off to leave blank
spaces on the label, or printing being output on the top of the next label.
When using this function, keep appropriate tension for collection of liners and label
supply.
[Feed Offset]
Set the feed distance in linerless mode.
Appears only if you have selected [Linerless] in the [Print Mode] menu.
The setting range is as follows:
Resolution S84NX S86NX
203 dpi 0 to 2000 dots 0 to 2000 dots
To Next Page
Loading...