[Advanced]
178
Resolution S84NX S86NX
(1 dot = 0.125 mm
(0.0049"))
305 dpi
(1 dot = 0.083 mm
(0.0033"))
0 to 3000 dots 0 to 3000 dots
609 dpi
(1 dot = 0.042 mm
(0.0017"))
0 to 6000 dots -
• You can change the units to dots, " (inches), or mm in the [System] > [Regional] >
[Unit] menu.
[Backfeed Offset]
Set the backfeed distance in linerless mode.
Appears only if you have selected [Linerless] in the [Print Mode] menu.
The setting range is as follows:
Resolution S84NX S86NX
203 dpi
(1 dot = 0.125 mm
(0.0049"))
0 to 2000 dots 0 to 2000 dots
305 dpi
(1 dot = 0.083 mm
(0.0033"))
0 to 3000 dots 0 to 3000 dots
609 dpi
(1 dot = 0.042 mm
(0.0017"))
0 to 6000 dots -
• When [Printing Mode] is set to [Use Ribbon], the length of label backfeed needs to be
under 30 mm (1.18"). If it is over 30 mm (1.18"), the end of the ribbon may be falsely
detected.
• You can change the units to dots, " (inches), or mm in the [System] > [Regional] >
[Unit] menu.
To Next Page
Loading...