[Network]
182
[DNS]
If you have selected [Static] in the [Mode] menu, set the primary address of the DNS server.
The setting range is as follows:
0:0:0:0:0:0:0:0 to ffff:ffff:ffff:ffff:ffff:ffff:ffff:ffff
• You can register only one IP address for the DNS server for IPv6.
[Proxy]
Set the proxy for the LAN.
The setting items are as follows:
[Enabled]
Enable or disable use of proxy.
The options are as follows:
Enabled
Enable proxy server usage.
Disabled
Disable proxy server usage.
• To enable the proxy, [Server] should be set and [Exclude] must contain at least
127.0.0.1 and localhost.
[Server]
Set the name or IP address of the proxy server.
Example of input) http://172.128.1.100
• Be sure to specify a format for the IP address that starts with http. If you specify an
address that starts with https, then the certification check is not done and connection to
a legitimate SOS server may be impossible.
• Server should be set with a valid name or IP address.
[Port No.]
Set the port number that allows communication with the proxy server.
The setting range is from 1 to 65535.
• Set a port number not used by other services. If port numbers that overlap with those
used by other services are used, communication cannot be performed properly.
• To set the port number, [Server] should be set.
To Next Page
Loading...