[Network]
196
• This setting is disabled when AEP mode is enabled.
[Port3]
Set the port number of Port3.
For the one-port connection of Status3/Status4/Status5, this port is used for both receiving print data
and returning the product status.
The setting range is from 1 to 65535.
• Each port (1, 2 and 3) must be set to different values.
• Set a port number not used by other services. If port numbers that overlap with those
used by other services are used, communication cannot be performed properly.
• You can change the return status format of port3 to Compatible mode by enabling
[Legacy Status for Port 9100].
[Flow Control]
Set the communication protocol.
The options are as follows:
• [Status4]
• [Status4 ENQ]
• [Status3]
• [Status5]
• [None]
[TCP Connection Queue]
Set whether to allow queuing for connection when multiple hosts or applications are sending
connection requests to the product.
The options are as follows:
Enabled
While connecting with one host or application, the product can receive connection requests from
other hosts or applications. The subsequent connection requests are put on hold, and processed
in order of reception after the first connection is closed.
Disabled
While connecting with one host or application, the product cannot receive connection requests
from other hosts or applications.
• When you have selected [Enabled], be sure to use one port connection for Status3,
Status4, and Status5. Operation using two port connections for Status4 is not
guaranteed.
[Legacy Status for Port 9100]
Set whether to change the return status format of Port3 to compatible mode.
To Next Page
Loading...