[Network]
198
Disabled (Standard mode)
[ENQ Reply Delay]
Set the period to delay status reply to status request ENQ.
Not available if you have selected [Status4] in the [Flow Control] menu.
The target interfaces are LAN and Wireless LAN.
The target statuses are Status3, Status4 ENQ reply, and Status5.
The setting range is from 0 to 9999 ms.
• Normally, keep this setting at the default value.
[Status4 Cyclic Response]
Set the interval for the cyclic status response.
Available only if you have selected [Status4] in the [Flow Control] menu.
The target interfaces are LAN and Wireless LAN.
The target status is Status4 reply cycle.
The setting range is from 100 to 999 ms.
[BCC]
Enable or disable the BCC check function.
Appears only if you have selected [Status5] in the [Flow Control] menu.
The options are as follows:
Enabled
Enable the BCC check function.
Disabled
Disable the BCC check function.
[NTP]
Set the functions for NTP.
The NTP function gets the time information from the NTP server through the network and sets the time
of the product.
The setting items are as follows:
To Next Page
Loading...